Setting The Drying Time After Printing - Roland XR-640 User Manual

Description
 "ENABLE" : media feed is performed until the trailing edge of the printing area is positioned on the dryer.
A margin from the print end position to the subsequent print start position is fixed at 200 mm. The margin
set on the computer is ignored.
P. 110, "Using an Optional Dryer"

 "DISABLE" : media feed stops simultaneously when printing ends. This means that the trailing edge of the
printing area is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE

Setting the Drying Time after Printing

Procedure

Hold down

HEATER MENU
DRYING TIME

DRYING TIME
0min 10min

Press
Description
Set the interval after the 1st page is printed. The next operation is not started until the set time passes.
is lighting during the interval. When pressing
the next operation is started. When holding on
You can also make this setting on the software RIP. When you have made the setting on the software RIP, the
software RIP's setting is used.
Default Setting
[DRYING TIME]: 0 min
and press .
Press
Press
Press
Press
in this order to go back to the original screen.
while
Fully Utilize the Media Heating System
to display the screen shown on the left.
.
to select the interval.
to enable the setting.
is lighting, the interval is finished and
while is lighting, output is canceled.
4
109