Fully Utilize the Media Heating System
Description
"ENABLE" : media feed is performed until the trailing edge of the printing area is positioned on the dryer.
The margin between the print-end position and the next print-start position is set to a value of 100 mil-
limeters.
"DISABLE" : media feed stops simultaneously when printing ends. This means that the trailing edge of the
printing area is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE
Setting the Drying Time after Printing
Procedure
Press
MENU
HEATER MENU
HEATER MENU
4
DRYING TIME
DRYING TIME
0min
W1200mm
SETUP SHEET
Description
Set the interval after the 1st page is printed. The next operation is not started until the set time passes.
is lighting during the interval. When pressing
the next operation is started. When holding on
Default Setting
[DRYING TIME]: 0 min
90
.
Press
Press
Press
Press
10min
Press
Press
several times to display the left figure.
, and then
.
.
to select the interval.
to enable the setting.
to go back to the original screen.
while
is lighting, the interval is finished and
while
is lighting, output is canceled.