Making The Temperature Setting For The Media Heating System - Roland TrueVIS VG-640 User Manual

Settings for the Media Heating System

Making the Temperature Setting for the Media Heating System

Procedure
A
Press [FUNCTION].
B
Press [ ] several times to display the screen shown below.
FUNCTION
HEATER CONFIG
C
Press [ ] to display the screen shown below.
HEATER CONFIG
PRINT
D
Press [ ] or [ ] to select "PRINT" (print heater) or "DRYER."
HEATER CONFIG
PRINT
4
E
Press [ ] to display the screen shown below.
PRINT
40゜C
F
Press [ ] or [ ] to select the temperature.
You can also set the temperature to "OFF." When set to "OFF," the media heating system does not
operate at all.
PRINT HEATER: General Guide for Setting the Temperature
PRINT
40゜C
You use this mainly to improve ink adhesion and inhibit smudging. If the ink forms lumps or smudges,
raise the temperature. Note, however, that a temperature that is too high may degrade the media
or cause it to wrinkle.
DRYER: General Guide for Setting the Temperature
DRYER
50゜C
When ink drying is poor, raise the temperature. Note, however, that a temperature that is too high
may degrade the media or cause it to wrinkle.
G
Press [ENTER] to confirm your entry.
H
Press [FUNCTION] to go back to the original screen.
118
40゜C
HEATER CONFIG
40゜C DRYER
DRYER
40゜C 50゜C
45゜C
45゜C
40゜C
50゜C