Maytag MFR Series Service Manual page 91

10. . Remove three cabinet screws from each
side rail at the base of the washer. One
from each side accessible from the back,
and two from each side accessible from the
front.
Cabinet
Screw
11. Remove the four bolts, with self locking
nuts, that secure the front panel that were
hidden behind the lower service panel.
Four Bolts
12. Clip any additional wire harness wire
ties along the left top edge of the cabinet
and along the control panel to remove the
cabinet.
excessive Weight Hazard
use two people to move or install
heavy parts.
Failure to do so can result in back or
other injury.
13. Remove F1 connector from washer control
board.
14. With two people, lift both sides of the
cabinet and move the entire cabinet forward
off the front of the washer.
5-5