Maytag MFR Series Service Manual page 88

10. Remove the cover on the drain valve to
disconnect the ground wire, the common
and L1 then pull them through to the back.
Bundle up the wires and put them outside
the cabinet so they don't get tangled.
11. Disconnect the vent tube connected to the
overflow.
Wire
Connectors
Vent Tube
5-2
12. Remove the bolts and star washers from
the bottom rails of the side panels.
Bottom Rail
13. Remove two bolts from each corner brace
in the lower back corners of the washer.
2 Corner
Brace Bolts
14. Remove the front panel (See page 4-19).
Bolt