Table of Contents
Advertisement
11.
Replace the nut on threaded rod #518912.
Install push bearing tool #514691 and
bearing support #518914. Thread the
assembled tool into the hole of the basket
shaft. The flat front side of the bearing
support part must be facing the bearing and
support both bearing races, and only the
bearing races. Failure to do so will damage
the bearings.
12.
Pull the basket into the drum using a
20mm hex key to hold the tool. Use the bar
wrench, #514695, to tighten the nut on the
pulling tool until it is tight. Remove the tools
from the basket shaft.
Push Bearing
#514691
Bearing Support
#514691
Bar Wrench
#514695
Threaded Rod
#518912
13.
Replace the front panel of the drum
by aligning the marks made during
disassembly. Use a rope or wire to pull the
hooks over the edge of the front shell all
around the front edge.
14.
Make sure the front panel is seated fully
around the drum by tapping around the
edge of the front shell with a rubber mallet.
15.
Do not remove the band, installed in the
groove around the drum, that holds the
clips that secure the front shell of the drum,
because the clips are positioned around the
tub face in specific locations and need to
remain in those positions.
6-23
Clip
Rope
Clip Retaining
Band
Advertisement
Table of Contents
Troubleshooting
