Maytag MFR Series Service Manual page 185

6. Drill a 7mm (0.27") hole in the motor plate.
7. Mark the frame for the new spring hole in
the frame. Measure a distance of 12mm
(0.47") from front edge of L-profile of the
frame and 280mm (11.02") from right inner
side of the frame. Mark the frame for drilling.
12mm (.47")
280mm (11.02")
x
8. Drill a 7mm hole (0.27") where measured
and marked in the previous step on the
L-profile of the frame.
9. Install new spring in hole in frame and in the
motor plate.
New Spring
Installed
8-17