Remove Water Inlet Valve Assembly - Maytag MFR Series Service Manual

ReMOve WaTeR inleT valve aSSeMBly

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Raise the top of the washer (See page 4-2).
2. Remove two flat blade screws from the rear
of the assembly for the valve to remove it.
3. Pull the valve out from the front.
4.
5.
6.
7.
8.
2 Flat Blade
Screws
9.
2 Flat Blade
Screws
4-25
Disconnect the wire connectors.
Mark them for correct reassembly.
Loosen two 7mm hex head hose clamps
Twist the hoses and pull them off.
Mark the hoses as to which goes to the left
and right.
Wire
Connectors
The assembly can be replaced as a unit or
rebuilt by replacing the stem assembly or
coil as needed.
nOTe: The MFR60 & 80 have two
additional one way water valves, one on
each of the hot and cold water inlets.
Two 7mm
Hose Clamps