Maytag MFR Series Service Manual page 59

ReMOve anD ReplaCe DOOR GlaSS anD GaSkeT
1. Open the washer door.
2. From the inside of the door, grasp the
gasket and glass at the top edge and peel
the gasket back away from the door to
remove the gasket and glass together.
3. To reinstall, put the glass back into the
gasket.
4. Insert a string in the groove of the front
lip around the entire gasket, crossing the
strings where they meet.
String In
Groove
MFR18 - 50
5. From inside the door, get the lip started at
the six o'clock position.
6. Make sure the string is hanging out the front
of the door.
7. Hold the gasket and glass against the door
frame from the inside of the door.
8. From the front of the door, use the string to
pull the front lip through the front of the door.
nOTe: If the string is too thin, it could cut
the gasket.
TeCH Tip: The reinsertion process can be
easier by using a little talc on the gasket.
Make sure to pull the string out at an angle
toward the glass.
4-15