Maytag MFR Series Service Manual page 132

46. Insert the push bushing, #518884, flat
side down on the seal. Make sure it is
concentric with the seal.
Bearing Cup
#518898
Sleeve
#518896
47. Insert the push bearing and the cog nut.
48. Turn the cog nut until the seals disengage.
49. Put EP2, or similar grease that can handle
212 degrees Fahrenheit (100˚ Celsius),
on the lipped side of the new seals. Avoid
damaging the lip seals in any way.
Cog Nut
Seal Holder
Radial
Push Bearing
Seals
Push Bushing
#518884
50. To reassemble the radial main shaft seals
into the seal holder, load the tool #518878
with the sleeve #518896.
51. Place the smooth side of one seal down
onto the larger push bushing, #518888. This
is the front seal.
52. Put the smooth side of the other seal onto
the smaller push bushing, #518887. This is
the rear seal.
Push Bushing
#518887
Rear Seal
Push Bushing
#518888
Front Seal
53. Place the seal holder, flange side down,
on the larger push bushing and the smaller
push bushing on top, seal facing down.
54. Insert this assembly on the tool, large
bushing first.
55. Insert the push bearing and the cog nut.
6-40
Seal Holder