Maytag MFR Series Service Manual page 125

51. Use the bar wrench #514695 to turn the
nut of the threaded rod to push the pulley
onto the shaft.
Support
Extension
#518913
#518869
Threaded Rod
#518912
52. Verify that the front face of the pulley
sits against the inner race of the
bearing. Check and tighten until this is
accomplished.
Tightening
Tool
Front Face
Of Pulley
53.
54.
55.
56.
Push Bearing
#514691
Bearing
Inner Race
6-33
Use lever bar #514759 to block the pulley
from moving while tightening.
Remove the lever bar and bar wrench.
Use a hex key to remove the threaded rod
and tools.
Use a small amount of Loctite® 222 on the
center bolt and reinstall the center bolt into
the shaft end.
Again, block the pulley using lever bar
while tightening the center bolt.