Tools Required To Prepare The Mx5, Mx10, Mx40, And Mx80 Router For Installation; Move The Mounting Brackets For Center-Mounting The Mx5, Mx10, Mx40, Or Mx80 Router, If Needed - Juniper MX5 Quick Start Manual

Tools Required to Prepare the MX5, MX10, MX40, and MX80 Router for Installation

Move the Mounting Brackets for Center-Mounting the MX5, MX10, MX40, or MX80 Router, If
Needed
Copyright © 2015, Juniper Networks, Inc.
Tools Required to Prepare the MX5, MX10, MX40, and MX80 Router for Installation
Figure 1: MX5, MX10, MX40, and MX80 Rack Clearance and Router
Dimensions
24" (61 cm)
clearance required
Cable
management
bracket
Front of chassis
19.2"
(48.7 cm)
Front-mounting flange
Blank panels to cover any slots not occupied by a component
Mounting brackets, supplied with the router
Eight screws for securing the mounting brackets to the chassis, supplied with the router
Phillips (+) screwdriver, number 2
Two removable mounting brackets are attached to the mounting holes closest to the
front of the chassis (see Figure 2 on page
another position on the side of the chassis for center-mounting the router.
To move the mounting brackets from the front of the chassis toward the center of the
chassis (see Figure 3 on page
Remove the four screws at the top and bottom of the bracket.
1.
Pull the bracket away from the chassis.
2.
Align the bracket with the two sets of mounting holes located toward the center of
3.
the chassis.
Insert the four screws at the top and bottom of the bracket and tighten each partially.
4.
Tighten the four screws completely.
5.
Repeat the procedure for the other bracket.
6.
23.46"
(59.6cm)
20.2"
clearance recommended for
(51.3 cm)
17.5"
(44.5 cm)
6). You can move the pair of brackets to
6):
30" (76.2 cm)
maintenance
Rear of chassis
5