Ricoh BE-C1 D046 Field Service Manual page 90

2. Installation
2
7. On the left and right, loosen the tray height adjustment knobs [1], swing the edge of the stacker tray
to the exact height of the rear original exit [3], then tighten the knobs.
8. Set the remaining accessories on the stacker tray:
[1] Upper guide
[2] Lower guide
[3] Right stopper
[4] Left stopper
9. Hang the stoppers at the correct position for the length of the originals. The illustration above shows
the stoppers set for the maximum length.
10. Go into the SP mode and switch off SP4975 (Original Edge Hold).
Front Copy Tray
Follow this procedure to set the multi-stacker to hold copies from the front copy tray.
88