Ricoh BE-C1 D046 Field Service Manual page 556

8. Appendix: SP Mode Tables
10
11
12
13
14
15
16 Plain: Low Temperature Mode
1936 Lower Limit Temperature: Press Roller
This SP sets the minimum difference allowed between the actual temperature and the target
temperature of the pressure roller.
• If the setting for the target temperature of the pressure roller is high (SP1932), the
• At this time, if the temperature is below the temperature set for the pressure roller, paper
8
Important:
• Modes "1" to "5" below refer to the paper and thickness settings selected in User Tools.
• In order for this SP to operate, SP9952-1 must be at "0" (default) so that the machine
1
2
3
4
5
6
7
108
Film
temperature of the pressure roller is lowered for continuous printing on plain paper.
feed will stop during a long job to perform inching to allow enough time for the pressure
roller temperature to rise to the level of the prescribed setting, and then the job will
continue.
can acquire temperature readings (feedback) from the pressure roller thermistors.
SP9952 should never be adjusted in the field.
Type
Plain
Trans.
5
1
2
3
4
5
Mode
1
2
3
4
5
1
2
[0 to 50/0/5 Steps]
[Range/Default/Steps]
o
[0 to 50/20/5 C]
o
[0 to 50/0/5 C]
o
[0 to 50/20/5 C]