Ricoh BE-C1 D046 Field Service Manual page 207

• This setting must be selected and displayed before you can do the installation procedure.
Seal Check and Removal
1. Check the two seals and confirm that they are firmly attached.
• If you see "VOID" on the tapes this means that the seals have been disturbed. If the "VOID"
notations are visible, do not use the SD card for this installation. Contact your sales division.
2. Remove the seals. The silver "VOID" notations become visible only after you have removed the seals.
Installation Procedure
Before doing the procedure, turn off the main power switch and unplug the machine from its power source.
1. Make sure that the machine is switched off and disconnected from its power source.
2. Disconnect the network cable.
3. Turn the main power switch on.
4. Turn the operation switch and main power switch off.
5. Remove the SD card slot cover (x1).
6. Check the security tape on the wrapping.
• If you see "VOID" on the security tape this means that the tape has been disturbed.
• If the "VOID" notations are visible, do not use the SD card for this installation. Contact your sales
division
7. Remove the security tape from the SD card wrapping.
8. Insert the DOS SD card into Slot 1.
MFP Options
2
205