Ricoh BE-C1 D046 Field Service Manual page 193

• After an SD card has been used to hold several applications, it should not be used for any other
purpose.
Moving Applications
Do this procedure to put more than one application on one SD card.
1. Turn off the copier.
2. Remove the SD card slot cover ( x 2).
3. Insert the Source SD card in Slot 2. This card contains the application that you want to move to the
other SD card.
4. Put the Target SD card in Slot 1.
5. Turn the copier on.
6. Go into the SP mode and do SP5873-1.
7. Follow the instructions on the display and touch "Execute" to start copying.
8. When the display tells you copying is completed, touch "Exit".
9. Turn the copier off.
10. Remove the Source SD card from Slot 2, and leave the target SD card in Slot 1.
11. Turn the copier on.
12. Go into the User Tools mode and confirm that all the applications on the SD card in Slot 1 are enabled.
User Tools> System Settings> Administrator Tools> Next> Firmware Version> Next (3/4)
13. Turn the copier off again, then:
• Reattach the SD card slot cover.
• Store the copied SD card at the customer site.
The SD card must be stored with the machine for these reasons:
• After an SD card has been copied, it can no longer be used. But it must be stored at the customer site
to serve as proof of purchase by the customer.
• Also, at a later time the stored SD cards can be restored to full use with SP5873-2 (described in the
next section).
• Before storing the SD card at the customer site, label it so that it can be easily identified.
Undo Exec
1. Turn the main switch off.
2. Put the SD card with the applications in Slot 2.
3. Put the original destination SD card into Slot 1.
MFP Options
2
191