Ricoh BE-C1 D046 Field Service Manual page 422

4. Replacement and Adjustment
(7) Printer/Scanner Leading Edge Registration
1. Copy an OS-A-1 Test Chart with plain paper (cut sheet or roll).
• Make sure that you execute the copy with manual density set at the operation panel.
• Measure the leading edge registration.
Standard
If the measurement does not meet the standard, adjust the following SP code.
SP4010 001
4
(8) Printer/Scanner Side-To-Side Registration
1. Copy an OS-A-1 Test Chart with plain paper (cut sheet or roll).
• Make sure that you execute the copy with manual density set at the operation panel.
• Measure the side-to-side registration, within 50 mm from the leading edge of the copy.
Standard
If the measurement does not meet the standard, adjust the following SP code.
SP4011 001
(9) Printer Cut Length Adjustment
1. Using the Preset Cut feature, make standard cuts of plain paper for A4 sideways, A3 sideways, A1
lengthways, and A0, A sideways, B sideways, D lengthways, and E.
2. Measure the cuts and check them against the standards in the table.
Range
Up to 297 mm
298 - 800 mm
801 - 1189 mm
1190 - 2500 mm
420
Within ±3.0 mm
Scanner Sub Scan Registration Leading Edge
Within ±2.8 mm
Scanner Main Scan Registration
Plain Translucent/Film
Less than ±2 mm
Less than ±3 mm
Less than ±4 mm
Less than ±7 mm
Less than ±3 mm
Less than ±4.5 mm
Less than ±5 mm
Less than ±9 mm