[5] ID Sensor ( x 2, x 2)
[6] Pick-off pawl solenoid ( x 1, x 1)
5. Remove the cleaning blade [1] (Springs x2, x 2).
Reinstallation
Do the following SP codes after replacing the drum and cleaning blade.
• After Drum Replacement:
SP2923
SP3001 002
• After Blade Replacement
SP2923
• Drum set mode procedure
Drum Set Mode. Applies toner to the drum and blade to reduce friction
between the drum and cleaning blade. As a result of this, the blade will not
bend and will not scratch the surface of the drum.
ID Sensor Setting – Initial Setting. Initializes the ID sensor.
Drum Set Mode – Execute. Applies toner to the drum and blade to reduce
friction between the drum and cleaning blade. This prevents the blade from
bending or scratching the surface of the drum.
Drum, Development Unit
309
4