Ricoh BE-C1 D046 Field Service Manual page 203

[User Tools]> "System Settings"> "Administrator Tools"> > "Next"> "Authentication Management">
"Admin. Authentication"> "On"
"Available Settings: [Administrator Tools]" appears below "Authentication Management".
• "Available Settings" is not displayed until "Admin. Authentication" is switched on.
• This setting must be selected and displayed before you can do the installation procedure.
Seal Check and Removal
• You must check the box seals to make sure that they were not removed after the items were sealed in
the box at the factory before you do the installation.
1. Check the box seals [1] on each corner of the box.
• Make sure that a tape is attached to each corner.
• The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not install the
components in the box.
2. If the surfaces of the tapes do not show "VOID", remove them from the corners of the box.
3. You can see the "VOID" marks [2] when you remove each seal. In this condition, they cannot be
attached to the box again.
Installation Procedure
1. Remove the SD card slot cover ( x 1).
MFP Options
2
201