Ricoh BE-C1 D046 Field Service Manual page 516

5. Appendix: Service Call Conditions
SC914
SC919 D
5
SC920 B
SC921 B
SC954 D
SC965 D
68
External controller error 5
An external application sent an error notice.
• VLB defective
• I/F cable defective
External controller down
The EAC received an interrupt signal from the FLUTE serial driver during print jobs
in progress and the connection between the copier and external controller was
broken.
Note: The EAC is the External API Converter.
1. Turn the machine off.
2. Check the I/F cable to determine if it became disconnected during operation.
3. Turn the machine on.
Printer error 1
An internal application error was detected and operation cannot continue.
• Software defective; turn the machine off/on, or change the controller firmware
• Insufficient memory
Printer error 2
When the application started, the necessary font was not on the SD card.
• Font not on the SD card
Printer Image Setting Error
The IPU did not issue the signal required to start image processing for the printing
mode within 60 s after the paper stops for registration.
• Software defective
• Replace the software (all firmware modules).
• IPU defective
Print start signal error 1
GW
GW
GW
GW