Ricoh BE-C1 D046 Field Service Manual page 252

2. Installation
Ferrite Cores
2
1. Below the left front corner of the table, fasten one ferrite core to each white cable:
[1] Close the ferrite core around the cable to lock it.
[2] Insert the end of the band into its clamp and pull it tight with your fingers.
2. Slide both cores [1] up until they stop against the bottom of the table.
3. Use a pair of long nose pliers [2] to pull the bands tight so the cores will not slip down.
4. Use a pair of nippers [3] to trim off the ends of the bands.
250