Ricoh BE-C1 D046 Field Service Manual page 619

• If the execution of SP5816-151 has succeeded and embedded RCG-M has connected
to the external line, this SP display is completely blank.
• If embedded RCG-M has connected to an internal line, then the number of the
• connection to the external line is displayed.
• If embedded RCG-M has connected to an external line, a comma is displayed with
• the number. The comma is inserted for a 2 sec. pause.
• The number setting for the external line can be entered manually (including commas).
Remove Service: PPP Certification Timeout (SSP)
Sets the length of the timeout for the embedded RCG-M connection to its access point. The
155
timeout is the time from when the modem sends the ATD to when it receives the result code.
[1 to 65536 / 60 / 1 /step]
Dial Up User Name
Use this SP to set a user name for access to remote dial up. Follow these rules when setting
a user name:
156
• Name length: Up to 32 characters
• Spaces and # allowed but the entire entry must be enclosed by double quotation marks
(").
Dial Up Password
Use this SP to set a password for access to remote dial up. Follow these rules when setting
a user name:
157
• Name length: Up to 32 characters
• Spaces and # allowed but the entire entry must be enclosed by double quotation marks
(").
Local Phone Number
Use this SP to set the telephone number of the line where embedded RCG-M is connected.
161
This number is transmitted to and used by the Call Center to return calls.
Limit: 24 numbers (numbers only)
Connection Timing Adjustment Incoming
When the Call Center calls out to an embedded RCG-M modem, it sends a repeating ID
162
tone (*#1#). This SP sets the time the line remains open to send these ID tones after the
number of the embedded RCG-M modem is dialed up and connected.
[0 to 24 / 1 / 1 /step]
System Service Mode
8
171