Ricoh BE-C1 D046 Field Service Manual page 568

8. Appendix: SP Mode Tables
• For the Fixed Mode only two selections are available: 1:3% or 2:6%. However, you
• If the ID sensor is damaged and cannot be replaced immediately, set to 1 or 2 so the
Toner Supply Time
This SP determines the length of time that the toner supply clutch remains on to supply toner.
[0 to 1/0/1]
4
0: Normal
1: Increase Toner Supply Time
Important: If "1" is selected independently all toner is supplied while the development unit
rollers are rotating. This can adversely affect toner supply control.
Long Print: Drawing
This SP sets the percent of coverage precisely for drawings when the machine uses the Fixed
Mode (SP2208-3).
[1 to 40/3/1%]
Note:
8
5 • If the length of the copy exceeds 1250 mm (49.2 in.) the machine automatically
• The Long Print: Drawing mode (this SP) and Long Print: Graphic mode (SP2208-6) are
• If the customer is scanning large numbers of drawings, first switch on SP2208-7 (select
Long Print: Graphic
This SP sets the percent of coverage precisely for graphics when the machine uses the Fixed
Mode (SP2208-3).
6
[1 to 40/6/1%]
Note:
• If the length of the copy exceeds 1250 mm (49.2 in.) the machine automatically
120
can adjust this amount of coverage for either setting. SP2208-5 adjusts the amount of
coverage for selection "1" (3%). SP2208-6 adjusts the amount of cover for selection
"2" (6%). SP2208-7 must be switched on for either adjustment to take effect.
customer can continue to use the machine until a new ID sensor is available for
replacement. After installing a new ID sensor, reset this SP code to 0.
switches to the Fixed Mode (SP208-3).
separate. Drawings are originals with large numbers of fine lines, and Graphics are
originals with graphic images that require more solid shading and fill such as photos.
"1") then do this SP adjustment to set the percent of coverage.
switches to the Fixed Mode (SP208-3).