Ricoh BE-C1 D046 Field Service Manual page 423

2501 - 3600 mm
3601 - 6000 mm
6001 - 15000 mm
15001 – 30000 mm
3. If a measurement does not meet the standard, then adjust the following SPs for each roller and paper
type.
Upper Tray
SP1920-21 to 33
SP1920-41 to 53
SP1920-61 to 73
SP1920-81 to 93
SP1920-101 to 113
SP1920-121 to 133
Lower Tray
SP1920-141 to 153
SP1920-161 to 173
SP1920-181 to 193
SP1920-201 to 213
SP1920-221 to 233
SP1920-241 to 253
(10) Printer/Scanner Trailing Edge Registration (Synchro-Cut)
1. Prepare two originals. One must have length 210 mm, and the other must have length 1000 mm.
2. Make a copy of each original with plain paper in the synchro cut mode.
3. Measure the cuts and check them against the standards in the table.
Range
Less than ±11 mm
Less than ±20 mm
Less than –32 to +200 mm
Less than –32 to +400 mm
Cut Length Adjustment – 1st Roll: Plain
Cut Length Adjustment - 1st Roll: Translucent
Cut Length Adjustment – 1st Roll: Film
Cut Length Adjustment – 2nd Roll: Plain
Cut Length Adjustment - 2nd Roll: Translucent
Cut Length Adjustment - 2nd Roll: Film
Cut Length Adjustment – 3rd Roll: Plain
Cut Length Adjustment – 3rd Roll: Translucent
Cut Length Adjustment – 3rd Roll: Film
Cut Length Adjustment – 4th Roll: Plain
Cut Length Adjustment – 4th Roll: Translucent
Cut Length Adjustment – 4th Roll: Film
Plain
Important Adjustments
Less than ±13.5 mm
---
---
---
Translucent/Film
4
421