Registration Motor - Ricoh BE-C1 D046 Field Service Manual

4. Replacement and Adjustment
1. Set the timing belt [1] behind the panel to receive the drive gear of the development motor.
2. After reattaching the development motor [2], turn it slowly to the front and back.
3. If the two gears at [3] move to the front and back when you turn the development motor, the belt and
timing gear are correctly engaged.

Registration Motor

4
Preparation
• Raise the upper unit. * p.257
• Remove the left cover of the upper unit. * p.262
• Remove the left rear cover and the left front cover. * p.260
1. Remove the screws of the left inner plate [1] (x2).
2. Remove the vertical [1] and horizontal [2] halves of the left inner plate.
316