Ricoh BE-C1 D046 Field Service Manual page 669

• Millimeters. No adjustment for sizes up to 1189 mm (A0), adjustment done for sizes longer
than 1189 mm (A0).
• Inches: No adjustment up to Engineering sizes, adjustment done for paper longer than
Engineering sizes.
2: Disabled (no fold adjustments)
6969 Bypass Feed Setting DFU
This sets the how the bypass feed sensors read paper sizes.
[0 to 1/0/1]
0: DOM, EU (Japan, Europe)
1: NA (North America)
6971 Trans. Switch Adj.: Cross
Cross Vertical Transport Motor Halt Timing
Normally the transport motor stops once the trailing edge of the paper feeds 90 mm past the
transport entrance sensor. This distance that the paper feeds past the sensor can be adjusted
1
in the range of –10 mm to +30 mm. Raising or lowering the setting increases or decreases the
distance that the paper feeds past the sensor.
[-10 to +30/0/1 mm]
Cross Vertical Transport Motor Reverse Timing
The return roller motor reverses 100 ms after the the return roller solenoids turn on. This timing
(100 ms before the motor reverses and feeds the paper against the jogger fence) can be
2
adjusted in the range of ±50 ms. Raising or lowering the setting increases or decreases the time
before the motor reverses.
[-50 to +50/0/10 ms]
Vertical Transport Retraction Amount
Normally after the return roller motor reverses it feeds the paper 30 mm. This distance that the
paper feeds toward the jogger fence can be adjusted in the range ± 30 mm. Raising or lowering
11
the setting increases or decreases the distance that the paper feeds. (This is the length of time
the motor remains on to feed the paper against the jogger fence.)
[-30 to +30/0/1 mm]
21 Jogger Adjustment
System Service Mode
8
221