Ricoh BE-C1 D046 Field Service Manual page 195

Installation
• Before doing the procedure, turn off the main power switch and unplug the machine from its power
source.
1. Make sure that the machine is switched off and disconnected from its power source.
2. Remove the SD card slot cover (x1).
3. Insert the Printer Option (D396) SD Card in Slot 1.
4. Insert the Printer Option (D396) SD Card: TIFF/GL Filter in Slot 2.
5. Reattach the SD card slot cover.
6. On the operation panel, remove the dummy keytop [1] and replace it with the "Printer" keytop [2].
7. Attach the "PS3" decal [3].
8. Reconnect the machine to its power source and turn the main power switch on.
9. Enter the SP mode and set SP5985-1 to "1" (Device Setting: Onboard NIC).
10. Set SP5985-2 (USB) to "1".
11. Turn the machine power off/on.
12. Print a Configuration Page to make sure that the machine recognizes the installed board:
User Tools> Printer Features> List/Test Print> Configuration Page
13. Contact the system administrator then do the network settings in the User Tools mode (IP address,
subnet mask, etc.)
• If the customer intends to use the Printer Controller Type RW-7140, the GW controller printer SD card
must be removed from the main machine.
MFP Options
2
193