Parameters; Parameter List - Mitsubishi MR-J4-10A Instruction Manual

5. PARAMETERS

5. PARAMETERS
CAUTION

5.1 Parameter list

Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
If fixed values are written in the digits of a parameter, do not change these values.
Do not change parameters for manufacturer setting.
Do not set a value other than the described values to each parameter.
POINT
To enable a parameter whose symbol is preceded by *, cycle the power after
setting it.
Abbreviations of operation modes indicate the followings.
Standard: Standard (semi closed loop system) use of the rotary servo motor
Full.: Fully closed loop system use of the rotary servo motor
Lin.: Linear servo motor use
DD: Direct drive (DD) motor use
The symbols in the control mode column mean as follows.
P: Position control mode
S: Speed control mode
T: Torque control mode
5 - 1