Rear Drum Brake Assembly - Subaru IMPREZA 2002 Service Manual

m
REAR DRUM BRAKE ASSEMBLY
BRAKE
10.Rear Drum Brake Assembly
A: REMOVAL
1) Loosen the wheel nuts, jack-up the vehicle, sup-
port it with rigid racks, and remove the wheel.
2) Release the parking brake.
3) Remove the brake drum from brake assembly.
<Ref. to BR-32, REMOVAL, Rear Drum Brake
Drum.>
4) Remove the brake shoe. <Ref. to BR-30, RE-
MOVAL, Rear Drum Brake Shoe.>
5) Unscrew the brake hose flare nut and disconnect
the brake hose.
6) Remove the hub.
<Ref. to DS-23, REMOVAL, Rear Axle.>
7) Disconnect the ABS sensor from back plate.
(only vehicle equipped ABS)
8) Remove the brake assembly.
G4M0400
9) Remove the bolts installing the wheel cylinder on
back plate, and remove it.
B: INSTALLATION
1) Clean the back plate and wheel cylinder.
2) Install the wheel cylinder on back plate, and
tighten bolts.
Tightening torque:
10 N-m (1.0 kgf-m, 7.2 ft-16)
3) Apply grease to the portions indicated by arrows
in Figure.
Brake grease:
Dow Corning Molykote No. 7439 (Part No.
7251 9 1460)
4) install the brale assembly on hopusing,
tighten bolts to install the back plate.
Tightening torque:
53 N m (5.4 kgf-m, 39.1 ft-l6)
and
5 ) Install the hub. <Ref. to DS-26, INSTALLATION,
Rear Axle.>
B R-33