Rear Disc Brake Assembly - Subaru LEGACY 2006 Manual

asieps_tobira.book 25 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4) Remove the piston seal from caliper body cylin-
der.
CAUTION:
Do not damage the cylinder and piston seal
groove.
5) Remove the lock pin sleeve and boot from cali-
per body.
6) Remove the guide pin boot.
D: ASSEMBLY
1) Clean the inside of the caliper body using brake
fluid.
2) Apply a coat of brake fluid to piston seal and in-
stall piston seal in the groove on caliper body.
3) Apply a coat of brake fluid to the inner surface of
cylinder and the entire outer surface of the piston.
4) Apply a coat of specified grease to the boot and
fit to the groove on the ends of cylinder.
Grease:
NIGLUBE RX-2 (Part No. K0779GA102)
5) Insert the piston into cylinder.
CAUTION:
Do not force the piston into cylinder.
6) Position the boot in the grooves on piston and
cylinder.
(2)
(1)
(1) Piston
(2) Piston boot
(3) Caliper body
(4) Piston seal

Rear Disc Brake Assembly

7) Apply a coat of specified grease to the guide pin,
outer surface, sleeve outer surface, cylinder inner
surface, and boot grooves.
Grease:
BR-00043
8) Insert the guide pin boot to the support.
9) Install the lock pin boot to the support, and then
insert the lock pin sleeve into the specified position.
E: INSPECTION
1) Repair or replace the faulty parts.
2) Check the caliper body and piston for uneven
wear, damage or rust.
3) Check the rubber parts for damage or deteriora-
tion.
(3)
(4)
BR-00243
BR-25
NIGLUBE RX-2 (Part No. K0779GA102)
(1)
(1) Pin boot
(2) Lock pin or guide pin
(3) Grease applied area
BRAKE
: (3)
(2)
BR-00362