Subaru IMPREZA 2002 Service Manual page 498

OIL PUMP
POWER ASSISTED SYSTEM (POWER STEERING)
10) Disassemble the oil pump and bracket by in-
serting a screwdriver as shown in the figure.
6) Remove the bolts which install power steering
pump bracket
.
2. TURBO MODEL
1) Remove the ground terminal from battery.
2) Remove the pulley belt cover.
3) Loosen the lock bolt and slider bolt and remove
the power steering pump drive V-belt.
4) Disconnect the connector from the power steer-
ing pressure switch.
5) Disconnect the pipe C and suction hose from the
oil pump.
CAUTION:
Do not allow fluid from the hose end to come
into contact with pulley belt.
To prevent foreign matter from entering the
hose and pipe, cover the open ends of them
with a clean cloth.
7) Place the oil pump bracket in a vise, remove the
two bolts from the front side of oil pump.
CAUTION:
Do not place oil pump bracket directly in the
vise; use soft pads and hold
oil
pump lightly to
protect the pump.
STOOl8
w
8) Remove the bolt from the rear side of oil pump.
9) Disassemble the oil pump and bracket by insert-
ing a screwdriver as shown in the figure.
(1)
Suction hose
(2)
Pipe C
PS-56