Subaru IMPREZA 2002 Service Manual page 143

REAR AXLE
DRIVE SHAFT SYSTEM
6) Connect the parking brake cable to the parking
brake.
7) Install the disc rotor on the rear housing assem-
bly.
8) Install the disc brake caliper on the back plate.
Tightening torque:
52 N.m (5.3 kgf-m, 38.3 ft-lb)
9) Install the rear ABS sensor and brake cable
bracket (only vehicle equipped with ABS).
(1) ABS sensor
10) Bleed air from brake system. <Ref. to BR-44,
REPLACEMENT, Brake FI u id.
>
11) Adjust the parking brake lever stroke by turning
adjuster.
12) Move the brake lever back to apply brakes.
While depressing brake pedal, tighten the axle nut
using a socket wrench. Lock the axle nut after tight-
ening.
Tightening torque:
786 N-m (79 kgf-m, 737 ft-lb)
CAUTION:
Use a new axle nut.
Always tighten axle nut before installing
wheel on vehicle. If wheel is installed and
comes in contact with ground when axle nut is
loose, wheel bearings may be damaged.
Be sure to tighten axle nut to specified
torque. Do not overtighten
it
as this may dam-
age wheel bearing.
13) Install the wheel and tighten the wheel nuts to
specified torque.
Tightening torque:
2. DRUMBRAKE
1) Connect the rear housing assembly and strut as-
sembly.
CAUTION:
Use a new self-locking nut.
Tightening torque:
2) Fit the BJ (bell joint) to rear housing splines.
CAUTION:
Be careful not to damage inner oil seal lip.
3) Connect the rear housing assembly to the lateral
link assembly.
CAUTION:
Use a new self-locking nut.
Tightening torque:
88 N-m (9 kgf-m, 65 ft-lb)
196 N-m (20 kgf-m, 745 ff-lb)
137 N.m (74 kgf-m, 101 ff-lb)
I .
4) Connect the rear housing assembly to the trail-
ing link assembly.
CAUTION:
Use a new self-locking nut.
Tightening torque:
173 N.m (1 7.5 kgf-m, 83 ff-lb)
S4M0109
DS-27