Subaru IMPREZA 2002 Service Manual page 205

FR Wheel Speed
FL Wheel Speed
RR Wheel Speed
RL Wheel Speed
Stop Light Switch
Stop Light Switch
G sensor output Signal
Valve Relay Signal
Wheel speed detected by the Front Right ABS sensor is displayed
Wheel speed detected by the Front Left ABS sensor is displayed
Wheel speed detected by the Rear Right ABS sensor is displayed
Wheel speed detected by the Rear Left ABS sensor is displayed
Stop light switch signal
Refers to vehicle acceleration detecting by the analog G sensor.
It
appears on the select monitor display in volts.
Valve Relay Signal
km/h or MPH
km/h or MPH
km/h or MPH
km/h or MPH
ON or OFF
V
V
ON or OFF
Stop light switch monitor voltage is displayed.
I e I a v Signal
1
Motor Relay Signal
I
ON or OFF
I
ABS Warning Lamp
Motor Relay Monitor
Valve Relay Monitor
I
ON or OFF
I
ABS Signal to TCM
1
ABS operation signal from ABS control module to TCM
ON operation of the ABS warning light is displayed.
Operating condition of the motor relay is displayed.
Operating condition of the valve relay is displayed.
ON or OFF
ON or OFF
ON or OFF
CCM Signal
ON or OFF
ABS operation signal from ABS control module to TCM
I
I
I
1
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
3.
CLEAR MEMORY MODE
1) On the ((Main Menu. display screen, select the {2. Each System Check} and press the ((YES)) key.
2) On the ((System Select Menu)) display screen, select {Brake System} and press the ((YES)) key.
3) Press the ((YES)) key after displayed the information of engine type.
4) On the (<Brake Control Diagnosis,) display screen, select the {Clear Memory} and press the ((YES), key.
5 ) When the "Done" and "turn ignition switch O F F are shown on the display screen, turn the Subaru Select
Monitor and ignition switch to OFF.
NOTE:
For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
ABS-1 9