Subaru IMPREZA 2002 Service Manual page 161

DRIVE SHAFT SYSTEM
REAR DRIVE SHAFT BOOTS
10) Using ST, install the DOJ into differential. 14) Connect the rear housing assembly to the trail-
ST 28099PA090 SIDE OIL SEAL PROTEC- ing link assembly, and tighten the self-locking nut.
TOR
15) Connect the rear housing assembly to the lat-
era1 link assembly, and tighten the self-locking nut.
16) Connect the stabilizer link to the lateral link.
17) Install the ABS sensor clamps and parking
brake cable bracket.
11) Insert the DOJ spline end into the bore of side
oil seal, and remove ST.
CAUTION:
Do not allow DOJ splines to damage side oil
seal.
ST 28099PA090 SIDE OIL SEAL PROTEC-
TOR
12) Align the DOJ and differential splines.
13) Push the housing to insert DOJ into the differ-
ential.
NOTE:
Make sure the DOJ is inserted properly.
I
G3M005C
CAUTION:
Discard old self-locking nut. Replace with a
new one.
DS-45