Subaru IMPREZA 2002 Service Manual page 177

FRONT ABS SENSOR
1
ABS
B: INSTALLATION
1) Temporarily install the front ABS sensor on
housing.
CAUTION:
Be careful not to strike the ABS sensor's pole
piece and tone wheel's teeth against adjacent
metal parts during installation.
1
84M220E
2) Install the front ABS sensor on strut and wheel
apron bracket.
Tightening torque:
32 N-m (3.3 kgf-m, 24 ft-16)
1728C
3) Place a thickness gauge between the ABS sen-
sor's and tone wheel's tooth face. After standard
clearance is obtained over the entire perimeter,
tighten the ABS sensor on housing to specified
torque.
ABS sensor standard clearance:
Tightening torque:
0.3
-
0.8 mm (0.012
-
0.031 in)
32 N-m (3.3 kgf-m, 24 ft-16)
CAUTION:
Check the marks on the harness to make sure
that no distortion exists.
RH: White
LH: Yellow
NOTE:
If the clearance is outside specifications, readjust.
4) After confirmation of the ABS sensor clearance,
connect the connector to ABS sensor.
5) Install the wheel.
6) Connect the battery ground terminal to battery.
I
(1) To front ABS sensor connector
(2) Bracket
ABS-1 5