I
STEERING GEARBOX
POWER ASSISTED SYSTEM (POWER STEERING)
2.
CONTROL VALVE ASSEMBLY
Specified steering grease:
VALIANT GREASE M2 (Part No. 003608001)
1) Clean all parts and tools before reassembling.
2) Apply a coat of specified power steering fluid to
the inner wall of valve housing.
S4M0162A
I
Fluid
I
3) Attach ST2 to STI
,
and press the oil seal into the
place using a press.
STI 34099FA120 INSTALLER & REMOVER
SEAL
ST2 34099FA130 INSTALLER SEAL
(1) Face oil seal in the direction shown in figure
when installing.
(2) To avoid scratching oil seal, apply a coat of
grease to the contact surface of installer and oil
seal.
(3) To facilitate installation, attach oil seal to the
installer and position in valve housing before
pressing into place.
I
S4M0160A
4) Using ST and press, install the special bearing in
valve housing.
ST 34099FA120 INSTALLER & REMOVER
SEAL
NOTE:
To facilitate installation, attach the ball bearing to
the remover and position in valve housing before
pressing it into place.
S4M0161B
(1) Special bearing
(2) Oil seal
5 ) Put vinyl tape around pinion shaft splines to pro-
tect oil seal from damage.
6) Fit pinion and valve assembly into valve housing.
7) Secure valve assembly to ST1 and ST2.
PS-38