Subaru IMPREZA 2002 Service Manual page 471

1
STEERING GEARBOX
POWER
ASSISTED SYSTEM (POWER STEERING)
6)
Using standard screwdriver, remove the band
from the boot.
S4M0145C
(1)
Band
7) Extend the rack approximately 40 mm
(1.57
in)
out. Unlock the lock wire at lock washer on each
side of tie-rod end using a standard screwdriver.
CAUTION:
Be careful not to scratch rack surface as oil
leaks may result.
40 mm (1.57 in)
-
S4M0146C
(1) Lock washer
8) Usina ST. loosen the lock nut.
ST 9F6230OOO
SPANNER
S4M0147C
9) Tighten the adjusting screw until it no longer
tightens.
S4M0140
10) Using a wrench [32 mm (1.26 in) width across
flats] or adjustable wrench, remove the tie-rod.
CAUTION:
Check ball joint for free play, and tie-rod for
bends. Replace if necessary.
Check dust seals used with tie-rod end ball
joint for damage or deterioration. Replace if
necessary.
11)
Loosen the adjusting screw and remove the
spring and sleeve.
CAUTION:
Replace spring and/or sleeve if damaged.
12) Remove the two bolts securing valve assembly.
S4M0154
PS-29