Subaru IMPREZA 2002 Service Manual page 82

REAR DIFFERENTIAL
DIFFERENTIALS
I
I
7) When replacing the side bearing, pull the bear-
ing cup from side bearing retainer using ST.
ST 398527700 PULLER ASSY
,
S3M05341:
8) Extract the bearing cone with ST.
CAUTION:
Do not attempt to disassemble the parts unless
necessary.
NOTE:
Set the puller so that its claws catch the edge of
+he bearing cone.
Never mix up the right and left hand bearing rac-
es and cones.
ST 398527700 PULLER SET
9) Remove the crown gear by loosening crown
gear bolts.
CAUTION:
Further disassembling is not allowed.
S3M0509
10) Drive out the pinion shaft lock pin from crown
gear side. (Without LSD)
NOTE:
The lock pin is staked at the pin hole end on the dif-
ferential carrier; do not drive it out forcibly before
unstaking it.
ST 899904100 STRAIGHT PIN REMOVER
11) Draw out the pinion mate shaft and remove pin-
ion mate gears, side gears and thrust washers.
(Without LSD)
NOTE:
The gears as well as thrust washers should be
marked or kept separated right and left, and front
and rear.
( C )
S3M051 OP
(A) Sidegear
(B)
Pinion mate gear
(C) Thrust washer
(D) Differential case
(E) Pinion mate shaft
DI-22