Subaru IMPREZA 2002 Service Manual page 147

REAR AXLE
1
DRIVE SHAFT SYSTEM
8) Using ST1 and ST2, press the sub seal into
place.
ST1 927430000 HOUSING STAND
ST2 927460000 OIL SEAL INSTALLER
CAUTION:
Do not apply pressure more than 3.92 kN (0.4
ton, 0.4 US ton, 0.4 Imp ton).
S4M0269A
9) Apply the sufficient grease to oil seal lip.
Specified grease:
SHELL 6459N
CAUTION:
If specification grease is not available, re-
move bearing grease and apply Auto Rex A in-
stead.
Do not mix different types of grease.
10) Install back plate to rear housing.
Tightening torque:
52 N.m (5.3 kgf-m, 38 ft-16)
11) Using ST1 and ST2, press the baring into hub.
ST1 927080000 HUB STAND
ST2 927450000 HUB INSTALLER
CAUTION:
Do not apply pressure more than 25 kN (2.5 ton,
2.3 US ton, 2.5 Imp ton).
E: INSPECTION
1) Inspect the rattle and lean of axis direction of the
removed parts as the same procedure of Front Axle
<Ref. to DS-22, INSPECTION, Front Axle.>
The lean of axis direction
Maximum: 0.05" (0.0020in)
2) Inspect the removed parts for wear and damage.
If defective, replace with a new one.
CAUTION:
If a bearing
is
faulty, replace it as the bearing
set.
Be sure to replace oil seal at every overhaul.
H4M1002C
(A) Replace as a set.
DS-31