Subaru IMPREZA 2002 Service Manual page 12

I
WHEEL ALIGNMENT
FRONT SUSPENSION
2. CAMBER
Inspection
1) Place the front wheel on turning radius gauge.
Make sure the ground contacting surfaces of front
and rear wheels are set at the same height.
2) Set the ST into the center of the wheel, and then
install the wheel alignment gauge.
ST 927380002 ADAPTER
c-
~
(1) Alignment gauge
(2) Turning radius gauge
NOTE:
Refer to the 'SPECIFICATIONS" for the camber
va I u es.
Front: <Ref. to FS-2, SPECIFICATIONS, General
Description.>
Rear: <Ref. to RS-2, SPECIFICATIONS, General
Description.>
Front camber adjustment
1) Loosen the two self-locking nuts located at the
lower front portion of strut.
CAUTION:
When the adjusting bolt needs to be loos-
ened or tightened, hold its head with a wrench
and turn the self-locking nut.
Discard the loosened self-locking nut and re-
place with a new one.
2) Turn the camber adjusting bolt so that the cam-
ber is set at the specification.
NOTE:
Moving the adjusting bolt by one scale graduation
changes the camber by approximately 0'10'.
(1) Strut
(2) Adjusting bolt
(3) Housing
(4) Outer
( 5 ) Inner
(6) Camber is increased.
(7) Camber is decreased.
J
FS-10