Subaru IMPREZA 2002 Service Manual page 493

1
PIPE ASSEMBLY
POWER ASSISTED SYSTEM (POWER STEERING)
12) Feed the specified fluid.
NOTE:
Never start the engine before feeding the fluid; otherwise vane pump might be seized up.
S4M02728
(1) High-pressure hose (3) Clearance between crossmember
and pipe: 3
-
8 mm (0.1 2
-
0.31
(2)
No
interference is allowed
between hoses. in)
13) Finally check clearance between pipes and/or
hoses, as shown above.
If the clearance between cruise control pump and
power steering hose is less than 10 mm (0.39 in),
proceed as follows:
(1) Move the clamped section (A) (refer to fig-
ure above.) down to a point where the pipe is
close to crossmember.
10 mm (0.39 in), min.
(2) Check that clearance between cruise con-
trol pump and power steering hose is at least 10
mm (0.39 in). If it is not, bend section (B) down
until a clearance of at least 10 mm (0.39 in) is
obtained.
Pipe-to-crossmember clearance:
PS-51