Subaru IMPREZA 2002 Service Manual page 145

REAR AXLE
DRIVE SHAFT SYSTEM
6) Remove the tone wheel bolts and remove the
tone wheel from the hub (only vehicle equipped
with ABS).
7 ) Using ST, press the hub bolt out.
ST 927080000 HUB STAND
CAUTION:
Be careful not to hammer the hub bolts. This
D: ASSEMBLY
1) Using ST, press the new hub bolt into place.
CAUTION:
Ensure hub bolt closely contacts hub.
Use a 12 mm (0.47 in) hole in the ST to pre-
vent hub bolt from tilting during installation.
ST 927080000 HUB STAND
may deform hub.
G4M0221
30 -
2) Remove the foreign particles (dust, rust, etc.)
from the mating surfaces of hub tone wheel, and in-
stall the tone wheel to hub (only vehicle equipped
with ABS).
CAUTION:
Ensure tone wheel closely contacts hub.
Be careful not to damage tone wheel teeth.
( 1 )
S4M0370P
(1) Tone wheel
DS-29