Subaru IMPREZA 2002 Service Manual page 181

REAR ABS SENSOR
Terminal No.
ia
ABS
Standard
3) Place a thickness gauge between the ABS sen-
sor's and tone wheel's tooth face. After standard
clearance is obtained over the entire perimeter,
tighten the ABS sensor on rear arm to specified
torque.
ABS sensor standard clearance:
Tigh tening torque:
CAUTION:
Check the marks on the harness to make sure
that no distortion exists.
RH: White
LH: Yellow
NOTE:
If the clearance is outside specifications, readjust.
4) After confirmation of the ABS sensor clearance,
connect the connector to ABS sensor.
5) Connect the battery ground terminal to battery.
0.7- f.2mm(0.028-00.047in)
32 N.m (3.3 kgf-m, 24 ff-lb)
C: INSPECTION
1. ABS SENSOR
1) Check the pole piece of the ABS sensor for for-
eign particles or damage. If necessary, clean the
pole piece or replace the ABS sensor.
2) Measure the ABS sensor resistance.
I
~~~~ ~
CAUTION:
If resistance is outside the standard value, re-
place the ABS sensor with a new one.
Check the marks on the harness to make sure
that no distortion exists.
RH: Light blue
LH: Brown
NOTE:
Check the ABS sensor cable for discontinuity. If
necessary, replace with a new one.
ABS-I 9