1
STEERING GEARBOX
POWER ASSISTED SYSTEM [POWER STEERING)
(7) Install the lock nut. While holding adjusting
screw with a wrench, tighten the lock nut using
ST.
ST 926230000
SPANNER
Tightening torque (Lock nut):
39 N-m (4.0 kgf-m, 29 ff-lb)
NOTE:
Hold the adjusting screw with a wrench to pre-
vent it from turning while tightening lock nut.
Make adjustment so that the steering wheel can
be rotated fully from lock to lock without binding.
21) Check for service limit as per article of "Service
limit".<Ref. to PS-42, INSPECTION, Steering
Gearbox.> Make replacement and adjustment if
necessary.
22) Take off the gearbox from ST.
23) Install the four pipes on the gearbox.
Tightening torque:
(1) Connect the pipe A and 6 to the gearbox.
13 N-m (1.3 kgf-m, 9.4 ft-lb)
(2) Connect the pipe E and F to the gearbox.
Pipe E: 15 Nom (1.5 kgf-m, 10.8 ft-lb)
Pipe F: 25 N.m (2.5 kgf-m, 18.1 ft-lb)
Tightening torque:
PS-41