Subaru IMPREZA 2002 Service Manual page 477

9
STEERING GEARBOX
POWER ASSISTED SYSTEM (POWER STEERING)
18) Install the gasket on the valve assembly. Insert
the valve assembly into the place while facing rack
teeth toward pinion.
CAUTION:
Be sure to use a new gasket.
NOTE:
Do not allow packing to be caught when installing
valve assembly.
. S4M0155
19) Tighten the bolts alternately to secure the valve
assembly.
Tightening torque:
CAUTION:
Be sure to alternately tighten bolts.
20) Apply grease to the sliding surface of sleeve
and spring seat, then insert the sleeve into the pin-
ion housing. Fit the spring into the sleeve screw,
pack grease inside of screw, then install the screw.
25 N.m (2.5 kgf-m, 18.1 ft-16)
B4M1129B
21) Install the lock washers and tighten the left and
right tie-rods into the rack ends.
On condition
Tightening torque:
L: Approximately 40 mm (1.57 in)
78 N-m (8.0 kgf-m, 58 ft-16)
S4M01.508
(1)
Tie-rod
22) Bend the lock washer using a chisel.
CAUTION:
Be careful not to scratch rack when bending
lock washer.
r
'
S4M0384A
(1) Lock washer
(1) Adjusting screw
(2) Spring
(3) Sleeve
PS-35