Subaru IMPREZA 2002 Service Manual page 409

BRAKE BOOSTER
I
BRAKE
B: INSTALLATION
1) Mount the brake booster in position.
2) Connect the operating rod to brake pedal with
clevis pin and snap pin.
B4M0117C
(1) Nuts
(2) Clevis pin
(3) Snap pin
(4) Operating rod
3) Connect the vacuum hose to brake booster.
4) Mount the master cylinder onto brake booster.
5)
Connect the brake pipes to master cylinder.
6) Connect the electric connector for brake fluid
level indicator.
7) Adjust the operating rod of brake booster.
Standard: L
LHD model:
RHD model:
144.6 mm (5.69 in)
7 73.2 mm (6.82 in)
If it is not in specified value, adjust it by adjusting
the brake booster operating rod.
k
L
MM0616P
8) Measure the clearance between threaded end of
stop light switch and stopper.
If it is not in specified value, adjust it by adjusting
the position of stop light switch.
CAUTION:
Be careful not to rotate the stop light switch.
Stop ljght switch clearance: A
0.3 mm (0.012 in)
A
u-
B4M0617H
9) Apply grease to operating rod connecting pin to
prevent it from wearing.
10) Bleed air from the brake system.
Tightening torque (Air bleeder screw):
11) Conduct road tests to ensure brakes do not
drag.
8 N.m (0.8 kgf-m, 5.8 ft-16)
BR-39