Subaru IMPREZA 2002 Service Manual page 142

REAR AXLE
I
DRIVE SHAFT SYSTEM
14) Remove the rear ABS sensor from the back
plate (only vehicle equipped with ABS).
(1) ABS sensor
15) Remove the bolts which secure rear housing to
strut, and separate the two.
B: INSTALLATION
1. DISC BRAKE
1) Connect the rear housing assembly and strut as-
sembly.
CAUTION:
Use a new self-locking nut.
Tightening torque:
2) Fit the BJ (bell joint) to the rear housing splines.
CAUTION:
Be careful not to damage inner oil seal lip.
3) Connect the rear housing assembly to the lateral
link assembly.
CAUTION:
Use a new self-locking nut.
Tightening torque:
196 N-m (20 kgf-m, 145 ft-16)
137 N-m (14 kgf-m, 101 ft-16)
4) Connect the rear housing assembly to the trail-
ing link assembly.
CAUTION:
Use a new self-locking nut.
Tightening torque:
113 N-m (1 1.5 kgf-m, 83 ft-16)
S4M0109
5) Connect the rear stabilizer to the rear lateral link.
CAUTION:
Use a new self-locking nut.
Tightening torque:
44 N-m (4.5 kgf-m, 32.5 ft-lb)
DS-26