Subaru IMPREZA 2002 Service Manual page 476

STEERING GEARBOX
POWER ASSISTED SYSTEM (POWER STEERING)
10) Insert the rack assembly into the rack housing
from cylinder side, and remove ST after it has
passed completely through oil seal.
NOTE:
Before inserting rack assembly, apply a coat of
specified power steering fluid to surfaces of ST and
rack piston.
ST 926390001 COVER & REMOVER
11) Fit ST1 and ST2 over the end of rack, and in-
stall rack bushing.
STl 926400000 GUIDE
ST2 927660000 GUIDE
CAUTION:
If burrs, or nicks are found on this guide and
rack shaft portion, remove by filing.
Dip rack bushing in specified power steering
fluid before installing, and pay attention not to
damage O-ring and oil seal.
(1) Rack bushing ASSY
12) Insert the rack stopper into the cylinder tube un-
til internal groove (on cylinder side) is aligned with
external groove (on rack stopper). Turn the rack
stopper with ST so that the rack stopper hole is
seen through cylinder slits.
13) Insert the rack stopper into the rack housing,
and wrap the circlip using a sharp pointed pliers to
secure the rack stopper in position.
CAUTION:
Be careful not to scratch rack while winding cir-
clip.
NOTE:
Rotate the wrench another 90 to 180" after the end
of circlip has been wrapped in.
S4M0167
14) Fit the mounting rubber onto the rack housing.
15) Apply the specified grease to the dust cover.
I
S4M0166A
I
16) Install the dust cover on the valve assembly.
17) Apply genuine grease to the pinion gear and
bearing of valve assembly.
G4M0158
PS-34