Subaru IMPREZA 2002 Service Manual page 479

i l
STEERING GEARBOX
POWER ASSISTED SYSTEM (POWER STEERING)
26) Using a screwdriver, tighten the screw until the
ends
" A
and "6" of the band come into contact with
each other.
CAUTION:
Use a new band.
NOTE:
Always tighten the band from the underside of the
gear box.
S4M0152A
27) Fix the boot end with clip (small).
CAUTION:
After installing, check boot end is positioned
into groove on tie-rod.
S4M0144B
(1) Clip
28) If the tie-rod end was removed, screw in lock
nut and tie-rod end to the screwed portion of tie-
rod, and tighten the lock nut temporarily in a posi-
tion as shown in figure.
Installed tie-rod length: L
15 mm (0.59 in)
NOTE:
Pay attention to difference between right and left
tie-rod ends.
A
L
r-
G4M0126
29) Install the tie-rod end plate.
Tightening torque:
13 N.m (1.3 kgf-m, 9.4 ft-lb)
30) Inspect the gearbox as follows:
" A
Holding tie-rod end, repeat lock to lock two or
three times as quickly as possible.
" B Holding tie-rod end, turn it slowly at a radius one
or two times as large as possible.
After all, make sure that the boot is installed in the
specified position without deflation.
G4M0127
31) Remove gearbox from ST.
ST 926200000 STAND
32) Install the four pipes on gearbox.
(1) Connect the pipe A and B to the four pipe
joints of gearbox.
Tightening torque:
13 N-m (1.3 kgf-m, 9.4 ft-lb)
(2) Connect the pipe E and F to the gearbox.
Pipe E: 15 N.m (1.5 kgf-m, 10.8 ft-lb)
Pipe F: 25 N.m (2.5 kgf-m, 18.1 ft-lb)
Tightening torque:
PS-37