Subaru IMPREZA 2002 Service Manual page 501

I
OIL PUMP
POWER ASSISTED SYSTEM (POWER STEERING)
3) Interconnect the pipes C and suction hose.
Tightening torque:
Joint nut
39.2 N-m (4 kgf-m, 28.9 fi-lb)
CAUTION:
If a hose is twisted at this step, the hose may
come into contact with some other parts.
(1) Suction hose
(2)
Pipe C
4) Connect the connector to the power steering oil
pressure switch.
5) Install the pulley belt to the oil pump.
6) Check the pulley belt tension. <Ref. to
ME(D0HC TURBO)-45, INSPECTION, V-belt.>
7) Tighten the bolt belt tension.
Tightening torque:
8 N m (0.8 kgf-m, 5.8 fi-lb)
8 ) Install the pulley belt cover.
9) Connect the ground terminal of battery.
10) Feed the specified power steering fluid <Ref. to
PS-72, Power Steering Fluid.>
CAUTION:
Never start the engine before feeding the fluid;
otherwise vane pump might be seized up.
C: DISASSEMBLY
1) Remove the nut and detach oil pump pulley.
2) Remove the stay from the oil pump.
3) Remove the four bolts which secure rear cover.
1. NON-TURBO MODEL
v
STOOBZ
(1) Rear cover
4) Using a screwdriver, pry the retaining ring off.
(1) Retaining ring
(2) Screwdriver
5) Extract the shaft from the front casing.
PS-59